Table of Contents
Advertisement
EXP1240 System Installation Guide
Color
State
Red
Blinking
Red
Blinking
Red
Briefly on
Red
Flickering
Red
Steady on
Wall mounting the base station
Be sure the wall
material can hold the
weight of the base.
1) Hold the base in its final
location and mark the
screw location based on
the measurements shown.
2) Insert the appropriate
anchors for the wall
material.
3) Insert the mounting
screws into the anchors,
leaving about ¼ inch of
space between the screw
head and the wall.
4) Connect the Ethernet
cable and route the cord
as shown.
5) Place the base over the
screw heads and slide it
down into place.
© 2013 Uniden America Corp.
All manuals and user guides at all-guides.com
Meaning
Factory reset warning. A factory reset has been
initiated or is in progress.
No Ethernet connection available
OR
Handset registration failed.
Reboot to start after firmware update.
Firmware update in progress.
Critical error. Contact technical support.
Figure 4: Base mounting dimensions
PROPRIETARY AND CONFIDENTIAL
Revision 06
Page 12 of 71
Advertisement
Table of Contents
