Table of Contents
Advertisement
SECTION 1
Safety
This section describes hazards that may occur if the laser is
installed or used improperly.
WARNING: Failure to follow these guidelines can result in injury to yourself, others, or
may cause severe damage to the equipment and your facility. Use of the equipment in a
manner other than what is described in this manual may increase this risk. Operation
and care of the laser must be followed in strict accordance to this manual.
This device is designed for laser cutting and engraving of the materials listed in the Laser
Personalization and Identification catalog of engraveable materials. This equipment must be
properly installed and connected to the Exhaust Module included with the system.
Exposure to the laser beam may cause physical burns and can cause severe eye damage.
•
Proper use and care of this system are essential to safe operation.
Never operate the laser system without constant supervision of the cutting and engraving
•
process. Exposure to the laser beam may cause ignition of combustible materials and start a fire. A
properly maintained fire extinguisher should be kept on hand at all times.
A properly configured, installed, maintained, and operating Exhaust Module is mandatory
•
when operating the laser system.
extracted and filtered from the Laser Module.
Unapproved materials, if engraved or cut with a laser, can produce toxic and caustic fumes.
•
DO NOT use materials other than those found in the Laser Personalization and Identification catalog.
Processing unapproved material may be a safety hazard and may also cause chemical deterioration
of the laser system such as rust, metal etching or pitting, peeling paint, etc. Systems damaged from
this abuse will NOT be covered under warranty.
Description of Appropriate Use
General Safety
Fumes and smoke from the engraving process must be
Advertisement
Table of Contents
