Material Applications; Filter Module - Universal Laser Systems LaserKiosk Operation Manual

3-4 System Operation
The Focus Carriage contains the #3 Mirror and the Focus Lens. This is the laser beams final
exit point. The Focus Carriage delivers the laser beam to the material in the X-axis direction by
traveling along the X-axis Rail. The Focus Carriage moves in the Y-axis direction as a result of
the entire X-axis Arm moving along the Y-axis rails. Coordinated efforts between X-axis and Y-
axis movements can position the Focus Carriage anywhere in the engraving area at a resolution
of 1000 DPI.

8) Material Applications

This device is designed for laser cutting and engraving of the materials listed in the Laser Personalization
and Identification catalog of engraveable materials. Unapproved materials, if engraved or cut with a
laser, can produce toxic and caustic fumes. DO NOT use materials other than those found in the
Laser Personalization and Identification catalog. Processing unapproved material may be a safety
hazard and may also cause chemical deterioration of the laser system such as rust, metal etching or
pitting, peeling paint, etc. Systems damaged from this abuse will NOT be covered under warranty.

9) Filter Module

The LaserKiosk is equipped with an integral Filter Module. No external exhaust is required. The Filter
Module is controlled by the Laser Module and the Computer Module and will turn on and off
automatically. It contains a Pre-Filter, Main Filter, Sensors, and a Vacuum Motor. The purpose of the
Filter Module is to extract and filter out particulates, smoke, and fumes during laser processing.