Table of Contents
Advertisement
3-2
System Operation
5) Control Panel
This is where the operator controls the laser system.
START: The LaserKiosk software will inform you
when it is OK to press the START button. Pressing the START button will begin laser processing.
STOP: Pressing the STOP button will halt the engraving or cutting process.
STOP + START: Press and hold the STOP button then press the START button. This button
sequence clears the Laser Module's file memory and re-homes the X, Y, and Z-axis.
Flashing
ON
OFF
6) Laser Cartridge
The Laser Cartridge is a very sophisticated device. It is composed of a gas filled plasma tube containing
a special mixture of CO2 and other gases, two electrodes, and RF (radio frequency) electronics. The
function of the entire assembly is to turn electrical energy into concentrated light energy. The word
LASER is an acronym for Light Amplified Stimulated Emission of Radiation.
(1)
Gas filled plasma tube
(2)
Electrodes
(3)
RF Power Supply
(4)
#1 Mirror
(5)
Beam Window
(6)
Beam diameter
(7)
#2 Mirror
(8)
#3 Mirror
(9)
Focus Lens
(10) Focal length
(11) Focal range
(12) Material
(13) Spot size
GREEN LIGHT
System is powering ON
System is running a file
File is being downloaded to system
Entire file is in memory indicating that transfer is complete
File has finished processing
4
5
6
7
10
SPOT
12
®
START
STOP
I
2
3
8
9
11
Advertisement
Table of Contents
