Table of Contents
Advertisement
SECTION 4
Using the LaserKiosk
Step-by-Step
This section covers how to use the LaserKiosk to engrave products from powering on the system to
removing the finished product from the system.
WARNING: Before continuing, please ensure that you have completely read and
understood the entire manual up to this point. It is essential that you know how to
safely operate the system before you actually engrave or cut any material.
Powering ON the LaserKiosk
Make sure the power cord is plugged in.
•
Make sure that the cylindrical handle of the Filter Module is rotated fully clockwise so that it rests in a
•
horizontal position.
Power ON the Computer Module by pressing the small button on the left side of the computer close to
•
the "ESC" key and the speaker.
Power ON the Laser Module by pressing the switch in the front of the machine.
•
The Laser Module will perform its homing routine. When completed the Green LED on the Control
•
Panel will stop flashing and remain OFF. The system is now ready.
Using the Software
The specialized software used to control the Laser Module is very intuitive. Please follow the on-screen
instructions to choose the item that will be engraved, add the text and/or graphic, install the correct
fixture, locate the item in the correct part of the fixture, and start the engraving process.
Choosing the Material
After physically choosing the item that you wish to engrave, follow the software prompts to locate that
item by entering the catalog number or by scrolling through the list and identifying the object by
appearance. Once you have selected the item, you will need to add text and/or a graphic.
Advertisement
Table of Contents
