Table of Contents
Advertisement
5-4
Maintenance
#2 Mirror
To gain access to the #2 Mirror, the mirror cover must be
removed. Loosen the thumbscrew (it remains attached to
the cover) and lift the cover straight up.
Inspect the #2 Mirror and clean it
only if there is debris present. To
clean the #2 Mirror with a cotton
swab, moisten the cotton swab
with the Lens Cleaning solution
supplied with the laser system.
DO NOT use other types of
cleaners or solutions. Gently roll
the cotton swab across the mirror
once. DO NOT drag the swab or
roll it back and forth as this can
scratch the mirror. If the mirror did not come clean, use a
fresh cotton swab and repeat the procedure. Do not worry
about small pieces of lint that come off of the cotton swab.
They will be vaporized as soon as the laser hits it. You can
cause more damage to the mirror by trying to get it off than by leaving it alone.
#3 Mirror and Focus Lens
You must remove the front cover to
the Focus Carriage (1) to gain access
to the #3 Mirror (3) and the Focus
Lens (4). To do this, hold the front
cover (2) with one hand and with the
other hand, remove the three
thumbscrews that attach the front
cover to the Focus Carriage, and pull
the front cover straight out. You will
notice that the #3 Mirror and the
Focus lens are both mounted to the front cover.
The #3 Mirror and the Focus lens are
both glued to a metal bracket and the
metal bracket is attached to the front
plate with Phillips head screws. It is
not necessary to detach the bracket
from either optic in order to clean
them.
I
1) Focus Carriage
2) Front Cover
3) #3 Mirror
4) Focus Lens
3
4
2
Advertisement
Table of Contents
