Computer Module - Universal Laser Systems LaserKiosk Operation Manual

2-6 Installation
Open the Top Door of the Laser Module. Remove any packing material from within the
•
engraving area. Remove the rubber band that retains the X-axis arm.
Plug in the Power Cord into your electrical supply. The entire system, the Laser Module,
•
Filter Module, and the Computer Module are all powered through this cord.

Computer Module

The Computer Module consists of a laptop computer attached to a removable platform. The computer is
pre-loaded with the software needed to run the LaserKiosk. When you power ON the computer, the
LaserKiosk software automatically starts up. From that point on, simply follow the on-screen instructions.
WARNING:
the Computer Module or the Laser Module is powered ON.
power OFF both the Laser Module and the Computer Module when connecting
or disconnecting the printer cable.
Never connect or disconnect the printer cable while either
Always