Canon H12157 User Manual page 314

RX SETTINGS
1.ECM RX
ON
OFF
2.RX MODE
FAX/TEL AUTO SW
RING START TIME
F/T RING TIME
F/T SWITCH ACTION
RECEIVE
DISCONNECT
FAX ONLY MODE
DRPD
NORMAL RING
DOUBLE RING
SHORT-SHORT-LONG
SHORT-LONG-SHORT
OTHER RING TYPE
Above settings:
FAX/TEL AUTO SW
15-10
The Menu System
Turn the ECM (error correction mode) receiving off and on. This switch does
not affect the button setups for One-Touch or Coded Speed Dialing.
All receptions are conducted with ECM if the other party's fax supports
ECM.
ECM is turned off.
Set the receive mode.
This mode is economical, it allows you to have phone and fax service
without the expense of an additional phone line.
Set the duration that the LASER CLASS 2060P listens for a fax tone before
starting to ring.
8 SEC (0 to 30)
Set the length of time the LASER CLASS 2060P will ring to alert you of an
incoming call.
15 SEC (10 to 45)
Select the action taken after the F/T RING TIME expires.
The fax will switch to fax receive mode automatically at that point and start to
receive the document.
The fax disconnects the call.
Use this mode if the LASER CLASS 2060P will be connected to a separate
telephone line used only for transmitting faxes. The LASER CLASS 2060P
then answers all calls, and receives all faxes automatically.
Some phone companies offer a distinctive ring pattern (DRP) service
whereby they assign two or more telephone numbers with distinctive ring
patterns to a single telephone line.
Ring type of normal telephone line.
Two short rings at regular intervals.
Short-short-long at regular intervals.
Short-long-short at regular intervals.
Patterns other than those described above.
UNIT TELEPHONE #
UNIT NAME
RX MODE TEL, FAX, FAX/TEL AUTO SW
RING START TIME
F/T RING TIME
F/T SWITCH ACTION
8 SEC (0 to 30)
15 SEC (10 to 45)
RECEIVE/DISCONNECT
(Default settings are shown in bold type)
Chapter 15