Slide Racks (Pan Racks) - Cleveland SteamCraft 21CGA5 Operation Installation Maintenance Manual

1 The adjustable feet must be fully retracted into legs.
2 The feet must screw in and out easily, using fingers.
3 Place left door hinge models on their left side, right door hinge models on their right side.
4 Screw the four legs into the four mounting holes.
5 Snug with a wrench.
6 Place the steamer upright on its four legs.
22CGT3.1 & 22CGT6.1 are heavy units and improper lifting can result in Death, Injury and
Equipment damage. Use enough workers with training and experience lifting heavy
equipment to place steamchefs on supporting surfaces and to lift and to move steamchefs
7 Clean the counter top that will support the appliance.
8 Use a level to locate highest corner of the counter top area that will support the appliance.
9 Mark this corner.
10 Place steamer on the counter.
11 Do not adjust foot in highest corner.
12 Use level and other three adjustable feet to level steamer front-to-back and side-to-side.
G. Slide Racks (Pan Racks)
1. Refer to Figure 3-5. Each rack has four loops:
two top, and two bottom. Hold the slide rack so
the ends of the hanger loops are towards
compartment wall, as shown in Figure 3-5.
2. Slide one rack into compartment with the loop
side closest to the compartment wall and rack
slots horizontal.
3. Hook the loops over the top and bottom pins.
4. Repeat steps 1, 2, and 3 for the other racks.
and accessories
Figure 3-4
Leg Mounting for Left Door Hinge Models
Figure 3-5
Slide Rack Installation
16