Installation; Select A Location; Position And Level The Appliance - Cleveland SteamCub 1SCE Operation Installation Maintenance Manual

Convection steamers

Hide thumbs Also See for SteamCub 1SCE:

Table of Contents

CHAPTER 7 INSTALLATION

Operating this appliance out of level can cause DEATH, INJURY, and EQUIPMENT DAMAGE.

This appliance must be level both front-to-back and side-to-side in all installations.

If this appliance is suspected to be out of level, shut it down at once and call your qualified

Cleveland Range authorized service agency immediately.

A. Select a Location

1. For safe and efficient operation:

a. Installation must comply with all local fire and health codes.

b. The location selected must be capable of supporting this appliance.

•

The operating weight of a 1SCE is 262 lbs.

c. Position the appliance so it will not tip or slide.

d. The operating surface must be level enough to allow leveling with the adjustable legs.

This appliance MUST be level both front to back and side to side before operation.

e. The location must include space for Operating and Service/Secondary Clearances and

the Exhaust Hood. See Figure 2-1.

All clearance requirements above, below, and around this appliance are the same for

non-combustible locations as for combustible locations.

Failure to maintain required clearances and additional distances as needed can result in

Consult manufacturers' literature, and sales and service agencies as needed.

KEEP THE APPLIANCE AREA FREE AND CLEAR OF COMBUSTIBLES.

g. Proper air supply for ventilation is REQUIRED for and CRITICAL to safe, efficient

operation of this appliance.

h. Make sure the air vents of this appliance are not blocked with or by anything.

Allow for sufficient extra distance if a "high heat source," e.g. a broiler, is located next to

this appliance. Contact Cleveland Range at 216-481-4900 or 1-800-338-2204 for

recommendations.

Do NOT install this appliance directly over a drain. Steam rising up out of the drain will

adversely affect operation, hamper cooling air circulation, and damage electrical and

electronic components.

B. Position and Level the Appliance

1. Move the appliance into position.

2. Place a level along the bottom edge of the appliance.

3. Use the adjustable legs of the appliance to level it front-to-back and side-to-side.

NEVER operate this appliance out of level.

INJURY and EQUIPMENT DAMAGE.

Table of Contents