Description; General; Scope; Packages Available - ESAB PCM-500i Instruction Manual

SECTION 1

1.1 GENERAL

The PCM-500i is a compact, completely self-contained
plasma cutting system. As shipped, the system is fully
assembled and ready to cut after being connected to
input power and a source of prefiltered compressed air
(90-150 psi). The PCM-500i package uses the PT-31XL
torch to deliver cutting power for materials up to 1/2 inch
thick or for severing up to to 5/8-in. thick. Refer to the
following paragraphs for descriptions of the PCM-500i
packages available as well as performance specifica-
tions.
Each PCM-500i Plasma Arc Cutting Package includes a Power Source, PT-31XL Torch with 25-ft. (8m) service lines,
and Torch Spare Parts Kit as listed.
Contents of
Package
PCM-500i Power Source with Regulator
and Work Cable
208/230 Vac, 1-phase, P/N 36304
400 Vac, 3-phase, P/N 36306
PT-31XL Torch Assembly, 25-ft (8m)*, P/N 21985
Spare Parts Kit (see Table 1-2 for contents) , P/N 0558003301
*
PT-31XL torch assembly has front end parts assembled.
Do not use any torch with this power source other
than the ESAB brand PT-31XL torch. Serious injury
may occur if used with any other torch.

1.2 SCOPE

The purpose of this manual is to provide the operator with
all the information required to install and operate the
PCM-500i plasma arc cutting package. Technical refer-
ence material is also provided to assist in troubleshoot-
ing the cutting package.

1.3 PACKAGES AVAILABLE

Table 1-1 lists available PCM-500i packages.
Table 1-1. PCM-500i Cutting Packages

DESCRIPTION

PCM-500i Cutting Package, P/N
36314 36316
7