Table of Contents
Advertisement
6 USER INTERFACE
6.2
LED indicators description
Indicator
0447 955 001
Preset voltage
The value is a preset and is intended to be starting point to establish a
satisfactory welding condition.
GMAW
GMAW Manual mode is a constant voltage weld process where the
voltage and wire feed speed are set independent of each other.
Preset wire feed speed
The value is a preset and is intended to be starting point to establish a
satisfactory welding condition.
2-stroke
With 2-stroke, gas pre-flow starts when the welding torch trigger
switch is pressed if feature is active. The welding process then starts.
Releasing the trigger switch stops welding entirely and starts gas
post-flow if feature is active.
4-stroke
With 4-stroke, the gas pre-flow starts when the welding torch trigger is
pressed, and the wire feed starts when it is released, and welding will
begin. The welding process continues until the switch is pressed
again, the wire feed and welding stops. The gas post-flow starts when
the switch is released.
This function is enabled when push button 1 is pressed and held for
2s
Arc dynamics
The arc dynamics control is used to adjust the intensity of the welding
arc. Lower arc control settings make the arc softer with less weld
spatter and better wetting action of the weld puddle. Higher arc control
settings give a more driving arc which can increase weld penetration.
To enable this function, press and hold the push button for 2s.
Over temperature indicator
The welding power source has thermal protection that operates if the
temperature of the power electronics becomes too high. When this
occurs, the welding output is interrupted, and the over temperature
indication LED is lit. The fan will continue to operate to cool the power
electronics. The thermal protection resets automatically when the
temperature has fallen to within its normal working temperature.
Spool gun
This indicator is lit when the spool gun 8-pin trigger connector is
connected to the 8-pin receptacle.
- 25 -
Description
© ESAB AB 2023
Advertisement
Table of Contents
