Advertisement
Available languages
Available languages
5 Preparing Charger for Use
4.10 Cleaning, Maintenance and Repair
WARNING
￭ Harsh detergents, cleaning with a water jet or sharp
objects can damage the charger. If the charger is not
cleaned correctly, components may no longer function
properly or safety devices may be rendered inoperative.
They may cause serious injury to persons.
► Clean the charger as described in this User Manual.
￭ If the charger is not serviced or repaired correctly,
components may no longer function properly or safety
devices may be rendered inoperative. This may result in
serous or fatal injury to people.
► Do not attempt to service or repair the charger.
￭ If the connecting cable is faulty or damaged:
► Have the connecting cable replaced by a STIHL dealer.
5 Preparing Charger for Use
5.1
Preparing Charger for Use
Perform the following steps before starting work:
► Make sure the charger is in a safe condition, @ 4.5.
► Clean the charger, @ 10.1.
► If you cannot carry out this work: Do not use the charger
and contact your STIHL servicing dealer.
6 Charging the Battery, LEDs
6.1
Mounting the Charger
► Check the following points when mounting the charger on
a wall:
– Suitable fixing materials.
– The diameter of the screws is 4.8 mm minimum.
– Matching washers of 15 mm outside diameter are used.
0458-829-9921-A
– The charger is level.
– The charger is not mounted higher than 1.8 m above
floor level.
– If several chargers are mounted side by side: The
connecting cable is laid below the charger.
Mounting the Charger on a Wall
1
► Align the charger so that the connecting cable (1) is on the
left.
► Use all four holders to mount the charger on the wall.
Mounting the Charger on a Table, in a Shelf or in a Drawer
A
► If the charger is mounted in position B as shown in the
figure: Align the charger with the connecting cable (1) on
the left-hand side.
► Use two or four holders to mount the charger on a table,
in a shelf or drawer.
English
B
1
23
Advertisement
Chapters
