Maintenance; Recommended Fluid - Ultratec Eclipse G3000 Operator's Manual

Maintenance

Exterior
To clean simply wash with mild soap and warm water.
Check the foam gasket that sits between the G3000/PFI9D and the Eclipse for any damage and replace if
required.
Cover the hose ends and fittings when not in use to prevent dirt from clogging the valves.
Keep road case cover over the Eclipse System open when in use.
Interior
Drain any accumulated liquid from inside the Eclipse with the drain valve on the bottom right.
Wipe the down the fog mixing chamber with a clean dry cloth to remove any excess liquid.
TECH TIP: At the end of a show it's good practice to allow the fan to run without CO2 to dry out any
moisture that may have collected during use.

Recommended Fluid

Quick Dissipating Fog Fluid: This fast dissipating fluid is great for applications or effects that require quick
dissipation of fog. It produces excellent steam effects that resemble nitrogen bursts and it also keeps low-lying fog
from rising too quickly when it is used with the ECLIPSE or LSX.
Extra Quick Dissipating Fog Fluid: Dissipates 2x the rate of Quick Dissipating Fog Fluid while maintaing similar
characteristics.
Molecular Fog Fluid: A faster dissipation versus the Director's Choice Fog Fluid. This thick, clean, white fog is an
optimal solution for a dense low-lying fog effect when chilled with the ECLIPSE or LSX machines.
All of our Fog Fluids are water based. Damage will occur if Haze Fluid is used in the G3000.
There will always be some residue in the ECLIPSE as it is using two opposing forces to create the effect;
hot fog and cold gas.
18
www.ultratecfx.com