Eclipse Operation With The Pfi9D; Dmx Operation; Optional Timer/Duration Remote Operation - Ultratec Eclipse G3000 Operator's Manual

Low fog generator

Hide thumbs Also See for Eclipse G3000:

Table of Contents

11) Example: DMX address set 122 in digital remote. Turn up DMX channel 123 over 50% preferably

100%. Count off your required purge and pre-chill time and then bring up DMX channel 122 to the

desired flow rate. Once again not exceeding 50% maximum; 30% or lower is recommended.

Please note: % on a DMX fader is not the same as % showing on the digital display "D" flow

setting. Please view the digital remote's flow setting for the actual flow rate being demanded.

Eclipse Operation with the PFI9D

The Power Fogger Industrial 9D is equipped with DMX controls as a standard feature.

1) Attach a DMX signal to the DMX IN 5 pin connector on the rear of the unit. A terminator may be

required on the DMX OUT connector in some applications.

2) Select a valid DMX address on the digital display selector for the base address of the fogger. If an

air option is present 3 consecutive address will be required. Base DMX= fog rate controlled 0-100%,

DMX+1=ECLIPSE power on above 50%, and DMX+2= air on above 50%.

3) Valid DMX LED is on solid if good DMX signal is present. DMX control overrides hand remote.

Slow or irregular flashing indicates poor DMX data.

4) Select the 2nd consecutive DMX channel that you have set above 50% to turn on both Eclipse

valves and to turn on the fan ( You can set the desired speed of the fan on the Eclipse with the speed

control dial to the right of the fan)

5) Now bring up the 1st DMX channel to the desired flow rate to turn the fog output ON. We

recommend a maximum of 30%. Do not exceed 50% flow rate setting. If you find that the fog is

not staying close to the floor after a few seconds, reduce your flow rate accordingly and confirm that

you still have liquid Co2 flowing from the tank.

6) Verify cool temperature output by using your hand and passing it through the fog-CO2 output

noting the temperature.

Note: For specific 9D Fog Machine operation, refer to the 9D operator's manual.

www.ultratecfx.com

Table of Contents

Eclipse pfi9d