Show Control Operation; Disconnecting The G3000/Pfi9D And Eclipse - Ultratec Eclipse G3000 Operator's Manual

Low fog generator

Hide thumbs Also See for Eclipse G3000:

Table of Contents

Show Control Operation

Show control is achieved by connecting a "Dry" or zero voltage contact to the show control terminals. The

Power Fog Industrial 9D requires no power to signal the fog, only one set of contacts that close for the

entire fogging cue.

For Show Control Operation, the DMX Address must be set on 555. Closing the Show Control Remote

terminals with dry contacts, triggers the following machine functions:

C + 1 = Fog On/ Off w/ Variflow

C + 2 = ECLIPSE On

C + 3 = Air Option

Close the CO2 tank valve (and pressure builder valve if using a Dewar tank)

Turn on the Eclipse only to run out the CO2 from the lines and Eclipse valve.

This may take several cycles of the Eclipse to purge the line. Do no make fog at this time.

When the hissing noise stops is an indicator that the lines are now empty.

With Caution disconnect the CO2 hose from the tank and Eclipse.

Disconnect the cable from the fog machine to the Eclipse.

Drain any condensate which has accumulated in the Eclipse.

www.ultratecfx.com

Smoke

OFF/ON

DRY CONTACTS

C 1 2 3

OFF

VARIFLOW

SMOKE

Contacts

Variflow

LED

Table of Contents

Eclipse pfi9d