Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Ultratec Radiance Hazer
Summary of Contents for Ultratec Radiance Hazer
- Page 1 Radiance Hazer Operators Manual v.102020...
-
Page 2: Table Of Contents
Table of Contents Introduction ......... Warning ..........1 Safety Precautions ....... 1 Technical Specifications ...... 2 Technical Drawings ......2 Radiance Setup........3 Operating Procedure ......3 Stand Alone Operation ....... DMX Operation ........RDM Functions........4 Operation with Hand Remote....5 Maintenance Procedure ...... -
Page 3: Introduction
The Radiance uses only Ultratec Special Effects Luminous 7 Haze Fluid which is a proven fluid that offers the best in low consumption with superior visual hang time. It can accommodate both the 2L or 4L sizes of the Ultratec fluid containers. -
Page 4: Technical Specifications
220-240 Volt A.C. 50/60 Hz. 2 Amps. Fluid: Ultratec Special Effects Luminous 7 Water Base Haze Fluid Consumption settings from 27 - 380 cc/ hour Even lower output is achieved by using the Interval Timer. Features: 5-Pin USITT DMX 512 RDM Protocol Truss Mount/ Angle Floor Stand Power Cord: 6’Detachable IEC Cord... -
Page 5: Radiance Setup
Radiance Setup 1. Insert a 2 or 4 Liter Jug of Ultratec Special Effects Luminous 7 Haze Fluid into the fluid jug holder. 2. Remove the cap and break the foil seal. Insert the fluid pickup tube into the jug and tighten the lid. -
Page 6: Dmx Operation
4. 15 Minutes prior to shutting down your Radiance Hazer, adjust your output setting to “0” Doing this will consume any haze fluid that is still in your distribution feed tubes and processing block. Failure to do so will result in raw fluid being discharged from your output nozzle when you operate it next start-... -
Page 7: Operation With Hand Remote
1 - 300 seconds interval dependent upon the dial position. 6. 15 Minutes prior to shutting down your Radiance Hazer, adjust your haze output setting to “0” Doing this will consume any haze fluid that is still in your distribution feed tubes and processing block. Failure to do so will result in raw fluid being discharged from your output nozzle when you operate it next start-up and will help... -
Page 8: Maintenance Procedure
Maintenance Procedure For information and instructions regarding the cleaning procedure, please refer to the “Radiance Hazer Service Manual”or “Radiance Hazer Service Maintenance Procedure Video” located on Radiance product page at www.ultratecfx.com Troubleshooting UNIT NOT POWERING UP 1) Check that IEC power cord is securely connected to unit. -
Page 9: Warranty
Hardware products come with a five-year warranty on parts and labor. If the unit in question has a material defect or fault that is caused in manufacturing, Ultratec Special Effects will provide free parts and labor to remedy the equipment. Ultratec Special Effects service department must be advised in a timely manner after defect appearance and the date of warranty request must be within five years of sale/purchase. -
Page 10: Contact Information
Contact Us Head Office Europe Office Ultratec Special Effects Ultratec Special Effects GmbH 1960 Blue Heron Drive Dieselstrasse 30-40 London, Ontario N6H 5L9 60314 Direct: 519-659-7972 Frankfurt am Main Toll Free: 800-388-0617 Germany Fax: 519-659-7713 Direct: 49-69-87-000-1850 Fax: 49-69-87-000-1899 USA Shipping Address...