Ultratec G3000 Mega Fog Burst Operator's Manual

Ultratec G3000 Mega Fog Burst Operator's Manual

Hide thumbs Also See for G3000 Mega Fog Burst:

Advertisement

Quick Links

G3000 Mega Fog Burst
Operators Manual
v.102020

Advertisement

Table of Contents
loading

Summary of Contents for Ultratec G3000 Mega Fog Burst

  • Page 1 G3000 Mega Fog Burst Operators Manual v.102020...
  • Page 2: Table Of Contents

    Table of Contents Introduction ......... Warning ..........1 Safety Precautions ....... 1 Technical Specifications ...... 2 Technical Drawings ......2 Technical Specifications w/ G3000..3 Technical Drawings w/ G3000....3 Mega Fog Burst Setup......4 Compressed Gases ....... 4 Operating Procedure ......5 Digital Remote Operation ......
  • Page 3: Introduction

    4. Protect the machine from direct weather effects and wet locations. Suitable for dry locations only. 5. Only use fog fluid by Ultratec Special Effects. 6. Do not continue to produce fog in an enclosed area when visibility is reduced below 20”(50cm).
  • Page 4: Technical Specifications

    12 lbs / 5 kgs Power Rating: 120 Volt A.C. 50/60 Hz. 1 A. 220-240 Volt A.C. 50/60 Hz. 0.5 A. Ultratec Special Effects Mega Fog Burst Air Requirements in SCFM: Pressure Consumption(SCFM) 20 PSI 40 PSI 60 PSI 80 PSI 90 PSI...
  • Page 5: Technical Specifications W/ G3000

    Technical Specifications G3000 and Mega Fog Burst Length: 29.8 in / 76 cm Width: 10.5 in / 26 cm Height: 12.2 in / 31 cm Net Weight: 64 Lbs/ 29 kg Power Rating: 120 Volt A.C. 50/60 Hz. 18 A. 220-240 Volt A.C.
  • Page 6: Mega Fog Burst Setup

    Unfortunately standard 1/4” M female style couplings and airlines are inadequate for this task. Ultratec recommends a high flow coupling on the Mega Fog Burst. These couplers can be identified with the blue band around the female fitting. These fittings come standard with the CXP-1968 CO2 Regulator with 5 foot hose &...
  • Page 7: Operating Procedure

    Operating Procedure Digital Remote Operation. 1) Adjust the remote flow rate “D” (demand) using + and – buttons to D50 A 27 Fog On desired fog output level. 2) To set the cycle time of the effect, press the menu button on the G3000 to “Set Cycle On”.
  • Page 8: Dmx Operation

    DMX Operation Note: The G3000 requires 2 channels of DMX for the Mega Fog Burst to operate. 1) Attach a DMX signal to the “DMX IN” 5 pin connector on the rear of the unit. For good DMX practice, a terminator is used on the “DMX OUT”...
  • Page 9: Warranty

    Hardware products come with a five-year warranty on parts and labor. If the unit in question has a material defect or fault that is caused in manufacturing, Ultratec Special Effects will provide free parts and labor to remedy the equipment. Ultratec Special Effects service department must be advised in a timely manner after defect appearance and the date of warranty request must be within five years of sale/purchase.
  • Page 10: Contact Information

    Contact Us Head Office Europe Office Ultratec Special Effects Ultratec Special Effects GmbH 1960 Blue Heron Drive Dieselstrasse 30-40 London, Ontario N6H 5L9 60314 Direct: 519-659-7972 Frankfurt am Main Toll Free: 800-388-0617 Germany Fax: 519-659-7713 Direct: 49-69-87-000-1850 Fax: 49-69-87-000-1899 USA Shipping Address...

Table of Contents