Dmx Operation; Maintenance; Exterior; Heat Exchanger - Ultratec 9D Operator's Manual

DMX Operation

The Power Fogger Industrial 9D is equipped with DMX-RDM controls as a standard feature. 2 channels of
DMX are required.
The base address = Fog Output Control.
The base address + 1 = Eclipse aux. port control.
1.Plug in the Power Fogger Industrial 9D and switch the Main Power ON to warm it up (Solid green LED on
back of machine).
2.Apply a DMX signal to the DMX IN 5 pin connector on the rear of the unit. A terminator may be required
on the DMX OUT connector in some applications.
Base DMX= Fog rate controlled 0-100%
DMX+1=Eclipse power on above 50%
DMX+2= Air on above 50%
3.Select a valid DMX address with the arrow keys to set the base address of the fogger.
Note: The display goes to sleep when not in use. Touching any key once wakens it.
The set DMX address controls the fog flow rate from 1-100%. The next consecutive address turns on the
auxiliary port if it is set over 50% for control of an Eclipse. Also
Note: If the air option is present, 3 consecutive DMX addresses will be required.
.4.The red valid DMX LED is on solid if good DMX signal is present.
DMX control will override hand remote only while active.
Slow or irregular flashing indicates poor DMX data
RDM Functions
RDM features will allow remote identify by flashing the
DMX display, DMX address changing and machine
temperature monitoring. As well the machine's group
and manufacturer identification data is available.

Maintenance

Exterior

The casing of the PFI9D is stainless steel with a powder paint coating. To clean simply wash with mild soap
and warm water.

Heat Exchanger

Using high quality Ultratec Special Effects fluid should result in a long heat exchanger life.
See Power Fog Industrial 9D Rapid Change Technology Replacement Guide R-A manual on how to change
out copper tube.
DMX
Address
DMX Out
DMX In
Green LED = Heating Status
Red LED = DMX Status
Remote
www.ultratecfx.com
6