Advertisement
11. An optional Versa Fan can be controlled at the same rate
as the internal fan. Plug a matching voltage fan into the
U-Ground (120 volt) or Lockable Volex Connector (220-240
volt). It will now vary with the internal fan control.
12. Select the desired DMX address for the hazer. Please Note:
The hazer occupies two sequential addresses. The selected
address is the Haze rate and the selected address + 1 is the
fan speed. Control is from 0 - 100% with '0' turning the
output off. Insert the DMX line into "DMX in" connector.
The fan has a minimum setting and should always run when
the power is applied. The fan only speeds up when haze is
produced.
13. Plug the unit into a suitable power source. Turn the main
power switch on and it will illuminate if power is present. The
valid DMX light will be solid when DMX signal is present. The
heat up time is approximately 7 minutes before haze can be
produced. The Green LED indicates Heating when flashing
and Ready when solid. A three flash pattern indicates an
over temperature error.
14. 5 Minutes prior to shutting down your Radiance Hazer, move your output valve to "0". Doing this will consume any
haze fluid that is still in your distribution feed tubes and processing block. Failure to do so will result in raw fluid being
discharged from your output nozzle when you operate it next start-up.
Maintenance Procedure
For information and instructions regarding the cleaning procedure, please refer to the 'Radiance Hazer Service Manual'
located on Radiance product page on
6
www.ultratecfx.com
www.ultratecfx.com
Fan Speed
Control
Vari Flow
Control
Haze On/Off
Switch
Hand Remote
Interval
Control
Handset
Indicator
Advertisement
