Reel Table (T) Assembly, T Soft Assembly - Sony DCR-TRV725E Service Manual

4-6. Reel Table (T) Assembly, T Soft Assembly

1. Removal procedure
1) Remove the blind plate. (Refer to 4-5.)
2) Open the claw of the reel table T assembly 1 in the directions
of the arrows B and C and remove the reel table T assembly.
3) Remove the T soft assembly 2 in the direction of the arrow
A.
4) Remove the T ratchet spring 3.
5) Remove the T ratchet arm 4 in the direction of the arrow D.
Open the claw of the reel table T
in the directions of the arrows
B and C .
B
4 Remove the T ratchet arm in
the direction of the arrow D .
D
1 Reel table (T)
C
Fig. 4-6.
— 19 —
2. Attachment procedure
1) Insert the T ratchet arm 4 into the groove on the LS chassis
block assembly to attach it.
2) Attach the T ratchet spring 3 to the notch of the T ratchet arm
4 and LS chassis block assembly.
3) Insert the T soft assembly into the groove on the LS chassis
block assembly.
4) Check the location of the reel table T assembly and attach the
LS chassis block assembly to the shaft.
5) Attach the blind plate. (Refer to 4-5.)
Check the location of the reel
table (T) assembly.
assembly
A
2 Remove the T soft assembly in the
direction of the arrow A .
3 T ratchet
spring
The reel table (T)
assembly is at a
slant.
When attaching it, coat the hatched
portion with grease.