Removing Fuel Injection Pipe; Removing Fuel Injection Nozzle; Removing Governor Assembly; Removing Governor Weights - Mitsubishi Heavy Industries SL Series Service Manual

1.1 Removing fuel injection pipe

Remove the fuel injection pipe and fuel leak-off pipe.

1.2 Removing fuel injection nozzle

Using a wrench, loosen the nozzle, and remove the fuel
injection nozzle and holder gasket.
Note: Using a wire or screwdriver remove the holder
gasket.

1.3 Removing governor assembly

(1) Remove the tie-rod cover.
(2) Using a pair of cutting pliers, remove the tie-rod spring.
Disconnect the tie-rod from the fuel injection pump.
(3) Remove the governor assembly.

1.4 Removing governor weights

(1) Remove the sliding sleeve.
(2) Remove the sliding sleeve shaft and then the governor
weights.
Removing fuel injection pipe
Removing fuel injection nozzle
Removing governor assembly
Removing governor weights
FUEL SYSTEM
8-3