Installing Fuel Injection Pump; Installing Governor Weights; Installing Sliding Sleeve - Mitsubishi Heavy Industries SL Series Service Manual

3.1 Installing fuel injection pump

(1) Install the fuel injection pump housing complete with
the pumps onto the cylinder block, and tighten the
retaining bolts.
(2) Install the governor assembly, inserting the tie-rod and
the tie-rod spring into the fuel injection pump housing.

3.2 Installing governor weights

Install the governor weights onto the rear end of the pump
camshaft and tighten the sliding sleeve shaft to the specified
torque.

3.3 Installing sliding sleeve

Install the sliding sleeve onto the sliding sleeve shaft.
Ensure that the sleeve slides smoothly.
Installing fuel injection pump
Removing tie rod
29.4 to 41.2 N·m
{3.0 to 4.2 kgf·m}
[21.7 to 30.4 lbf·ft]
Installing governor weights
Installing slideing sleeve
FUEL SYSTEM
8-19