Juniper SRX5400 Manual page 8

Services gateway card reference
Hide thumbs Also See for SRX5400:
Table of Contents

Advertisement

SRX5400, SRX5600, and SRX5800 Services Gateway Card Reference
LEDs
OK/FAIL
Steady green–The SPC is operating normally.
Red–The SPC has failed and is not operating normally.
Off–The SPC is powered down.
STATUS
Green–The SPU is operating normally.
Amber–The SPU is initializing.
Red–The SPU has encountered an error or a failure.
Off–The SPU is offline. If all four SPUs are offline, it is safe to remove the SPC from the chassis.
SERVICE
Green–Service is running on the SPU under acceptable load.
Amber–Service on the SPU is overloaded.
Off–Service is not running on the SPU.
HA
Green–Clustering is operating normally. All cluster members and monitored links are available, and
no error conditions are detected.
Red–A critical alarm is present on clustering. A cluster member is missing or unreachable, or the
other node is no longer part of a cluster because it has been disabled by the dual membership and
detection recovery process in reaction to a control link or fabric link failure.
Amber–All cluster members are present, but an error condition has compromised the performance
and resiliency of the cluster. The reduced bandwidth could cause packets to be dropped or could
result in reduced resiliency because a single point of failure might exist. The error condition might
be caused by:
LINK/ACT
CONTROL 1
Green–Chassis cluster control port link is active.
Off–No link.
ENABLE
CONTROL 1
Green–The chassis cluster control port is enabled.
Off–The chassis cluster control port is disabled.
8
LED, one bicolor:
LED, one tricolor for each of the two SPUs
LED, one bicolor for each of the two SPUs,
LED, one tricolor:
The loss of chassis cluster links which causes an interface monitoring failure.
An error in an SPU or NPU.
Failure of the spu-monitoring or cold-sync-monitoring processes.
A chassis cluster IP monitoring failure.
LED, one for each of the two ports
:
LED, one for each of the two ports
:
and
:
SPU 0
SPU 1
and
:
SPU 0
SPU 1
CHASSIS CLUSTER CONTROL 0
CHASSIS CLUSTER CONTROL 0
Copyright © 2014, Juniper Networks, Inc.
and
CHASSIS CLUSTER
and
CHASSIS CLUSTER

Advertisement

Table of Contents
loading

This manual is also suitable for:

Srx5600Srx5800

Table of Contents