Juniper SRX5400 Manual page 7

Description SPC with two SPUs
Software release Junos OS Release 9.2 and later
Cables and
CHASSIS CLUSTER CONTROL 0
connectors chassis cluster configurations.
Controls None
Supported Slots SRX5600–Any slot except bottom slots
SRX5800–Any slot except center slots
Power Requirement Maximum 351 W
Weight Approximately 13 lb (5.9 kg)
Copyright © 2014, Juniper Networks, Inc.
NOTE: We strongly recommend the use of Juniper Networks SFP
transceivers. We cannot guarantee correct operation if other transceivers
are used. The transceiver type can be different in each port, as long as a
supported part number is used.
Fabric interfaces.
Two Gigabit Ethernet interfaces that allow control information, route information, and
statistics to be sent between the Routing Engine and the CPU on the SPCs.
Two interfaces from the SCBs that enable the boards to be powered on and controlled.
Physical SPC connectors.
Midplane connectors and power circuitry.
Processor subsystem, which includes a 1.2-GHz CPU, system controller, and 1 GB of
SDRAM.
LEDs on the faceplate that indicate the SPC and SPU status.
and
Services Processing Card SRX5K-SPC-2-10-40
CHASSIS CLUSTER CONTROL 1
or
0 1
0 , 1 , or 2/6
–SFP ports for control links in
7