Juniper SRX5400 Manual page 11

Description SPC with four SPUs
Software release Junos OS Release 12.1X44-D10 and later
Cables and
CHASSIS CLUSTER CONTROL 0
connectors cluster configurations.
Controls None
Supported Slots SRX5400–Any slot except bottom slot
SRX5600–Any slot except bottom slots
SRX5800–Any slot except center slots
Power 450 W typical, 585 W maximum
Requirement
NOTE:
In the SRX5600 and SRX5800 Services Gateways, you must have high-capacity power supplies (either
AC or DC) and high-capacity fan trays installed in the services gateway in order to install and use
SRX5K-SPC-4-15-320 SPCs. If you do not have high-capacity power supplies and fan trays installed,
the services gateway will log an alarm condition when it recognizes the SRX5K-SPC-4-15-320 SPCs.
On SRX5600 Services Gateways with AC power supplies, we recommend that you use high-line (220v)
input power to ensure the device has adequate power to support SRX5K-SPC-4-15-320 SPCs.
Weight Approximately 18 lb (8.3 kg)
Copyright © 2014, Juniper Networks, Inc.
NOTE: We strongly recommend the use of Juniper Networks SFP
transceivers. We cannot guarantee correct operation if other transceivers
are used. The transceiver type can be different in each port, as long as a
supported part number is used.
Fabric interfaces.
Two Gigabit Ethernet interfaces that allow control information, route information, and
statistics to be sent between the Routing Engine and the CPU on the SPCs.
Two interfaces from the SCBs that enable the boards to be powered on and controlled.
Physical SPC connectors.
Midplane connectors and power circuitry.
Processor subsystem, which includes a 1.2-GHz CPU, system controller, and 1 GB of
SDRAM.
LEDs on the faceplate that indicate the SPC and SPU status.
and
CHASSIS CLUSTER CONTROL 1
Services Processing Card SRX5K-SPC-4-15-320
–SFP ports for control links in chassis
0
0 or 1
or
0 1
11