Juniper SRX5400 Manual page 40

Services gateway card reference
Hide thumbs Also See for SRX5400:
Table of Contents

Advertisement

SRX5400, SRX5600, and SRX5800 Services Gateway Card Reference
Description
Routing Engine for SRX5400, SRX5600, and SRX5800 Services Gateways
Software release
Cables and connectors
AUX
cable with an RJ-45 connector.
CONSOLE
connector.
ETHERNET
(or any other device that plugs into an Ethernet connection) for out-of-band management.
Controls
Supported Slots
Front panel slot in an SCB installed in:
NOTE:
0
configurations.
Power Requirement
90 W
Weight
Approximately 2.4 lb (1.1 kg)
40
Hard disk—Provides secondary storage for log files, memory dumps, and rebooting the
system if the internal compact flash disk fails.
HDD LED—Indicates disk activity for the hard disk drive.
Management ports—Each Routing Engine has one 10/100-Mbps Ethernet port for
connecting to a management network, and two asynchronous serial ports—one for
connecting to a console and one for connecting to a modem or other auxiliary device.
The interface ports are labeled
EEPROM—Stores the serial number of the Routing Engine.
Extractor clips—Used for inserting and extracting the Routing Engine.
Captive screws—Secures the Routing Engine in place.
The Routing Engine boots from the storage media in this order: the USB device (if present),
then the internal flash disk, then the hard disk, then the LAN.
NOTE:
For specific information about Routing Engine components (for
example, the amount of DRAM), issue the
command.
Junos OS Release 9.2 and later
Junos OS Release 10.0 and later required to install a second Routing Engine
—Connects the Routing Engine to a laptop, a modem, or another auxiliary device through a
—Connects the Routing Engine to a system console through a cable with an RJ-45
—Connects the Routing Engine through an Ethernet connection to a management LAN
button—Reboots the Routing Engine when pressed
RESET
Button—Not supported in the current release
ONLINE/OFFLINE
SRX5400: Bottom slot 0
SRX5600: Bottom slots 0 or 1
SRX5800: Center slots 0 or 1
The services gateway host subsystem Routing Engine must be installed in the SCB in slot
. A Routing Engine installed in an SCB in slot
AUX
,
CONSOLE
, and
ETHERNET
show chassis routing-engine
1
only enables dual control links in chassis cluster
Copyright © 2014, Juniper Networks, Inc.
.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Srx5600Srx5800

Table of Contents