Juniper SRX5400 Manual page 42

SRX5400, SRX5600, and SRX5800 Services Gateway Card Reference
Description
Software release
Cables and connectors
Controls
Supported slots
Power requirement
42
USB port—Provides a removable media interface through which you can install the
Junos OS manually. Junos OS supports USB version 1.0 and 2.0.
CompactFlash card—Provides primary storage for software images, configuration files,
and microcode. The CompactFlash card is fixed and is inaccessible from outside the
device.
Solid-state drive (SSD)—Provides secondary storage for log files, for generating core
files, and for rebooting the system if the CompactFlash card fails.
NOTE: The SSD is not a separate field-replaceable unit (FRU).
Interface ports—The ,
AUX
management devices. Each Routing Engine has one 10/100/1000-Mbps Ethernet port
for connecting to a management network, and two asynchronous serial ports—one for
connecting to a console and one for connecting to a modem or other auxiliary device.
EEPROM—Stores the serial number of the Routing Engine.
Reset button—Reboots the Routing Engine when pressed.
Online/Offline button—Takes the Routing Engine online or offline when pressed.
Extractor clips—Inserts and extracts the Routing Engine.
Captive screws—Secures the Routing Engine in place.
Routing Engine for SRX5400, SRX5600, and SRX5800 Services Gateways
Junos OS Release 12.1X47-D15 and later
Slot for Routing Engine
–Connects the Routing Engine to a laptop, a modem, or another auxiliary device
AUX
through a cable with an RJ-45 connector.
–Connects the Routing Engine to a system console through a cable with an RJ-45
CONSOLE
connector.
–Connects the Routing Engine through an Ethernet connection to a management
ETHERNET
LAN (or any other device that plugs into an Ethernet connection) for out-of-band
management.
RESET button–Reboots the Routing Engine when pressed.
Front panel slot in an SCB installed in:
SRX5400: Bottom slot 0
SRX5600: Bottom slots 0 or 1
SRX5800: Center slots 0 or 1
NOTE: The services gateway host subsystem Routing Engine must be installed in the SCB
in slot 0. A Routing Engine installed in an SCB in slot 1 only enables dual control links in chassis
cluster configurations.
90 W
, and
CONSOLE ETHERNET
ports provide access to
Copyright © 2014, Juniper Networks, Inc.