Replacement/Cleaning Mode; Moving To Replacement/Cleaning Mode - Canon imagePRESS C800 Series Operator's Maintenance Manual

1
Initial Setup > Basic Operation > Replacement/Cleaning Mode > Moving to Replacement/Cleaning Mode

Replacement/Cleaning Mode

■ Moving to Replacement/Cleaning Mode

To replace or clean the parts, move from Operator Maintenance mode to Replacement/
Cleaning Mode.
1) Press [To Rplcmt./Cleaning] in operator maintenance basic screen.
CAUTION:
• [To Rplcmt./Cleaning] is disabled when any start-up jobs or PDL jobs are executed in
the control panel. End the jobs to enable [To Rplcmt./Cleaning].
• If [To Rplcmt./Cleaning] is pressed immediately after pressing [Print List], wait time of
approx. 2 minutes is required in order to protect the device.
-> The message screen will be shown to confirm the mode to be switched to
Replacement/Cleaning mode.
1 Initial Setup > Basic Operation > Replacement/Cleaning Mode > Moving to Replacement/Cleaning Mode
2) Press [Yes].
-> Move from Operator Maintenance mode to Replacement/Cleaning mode, and then
F-1-29
CAUTION:
Prohibitions in Replacement/Cleaning Mode.
• Moving to the other functions (including the system status/user mode)
• Power controls such as sleep or power saving.
replacement/cleaning mode screen in Operator Maintenance mode is shown.
1-15
F-1-30
F-1-31
1-15