Power Requirements - National Instruments SCC-FV01 User Manual

Power Requirements

Physical
Maximum Working Voltage
SCC-FV01 Frequency Input Module User Guide
Output ripple...........................................30 mV
Output range ...........................................0 to +10 V (NRSE)
Recommended warm-up time.................5 min
Analog power .........................................100 mW
+15 V ...............................................4.9 mA
–15 V ...............................................1.75 mA
Digital power ..........................................0 mW
+5 V .................................................0 mA
Operating voltage accuracy requirements
+15 V ...............................................±10%
–15 V ...............................................±10%
REF5V.............................................±0.05%
Dimensions .............................................8.89 cm × 2.92 cm × 1.85 cm
I/O connectors.........................................One 20-pin right-angle male
Wire gauge range....................................28 to 16 AWG
Maximum working voltage refers to the signal voltage plus the
common-mode voltage.
Channel-to-earth .....................................±10 V, Installation Category I
Channel-to-channel.................................±10 V, Installation Category I
(input signal frequency)
(3.5 in. × 1.15 in. × 0.73 in.)
connector,
one 4-pin screw terminal
(detachable)
6
at 10 Hz
p-p
ni.com