What You Need to Get Started
Note
Software scaling of measurements is not supported on the Macintosh operating
system.
© National Instruments Corporation
To set up and use the SCC-AO10, you need the following items:
❑
SC-2345/2350 with one of the following:
–
SCC-PWR01
–
SCC-PWR02 and PS01 power supply
–
SCC-PWR03 (requires a 7 to 42 VDC power supply, not included)
❑
One or two SCC-AO10 modules
❑
SC-2345/2350 User Manual, available at
❑
SCC-AO10 Isolated Analog Output Module User Guide
❑
SCC Quick Start Guide, available at
❑
Read Me First: Safety and Radio-Frequency Interference
❑
SC-2345 Quick Reference Label
❑
68-pin E Series DAQ device, documentation, and 68-pin cable of less
than 1.5 m length
❑
1/8 in. flathead screwdriver
❑
Numbers 1 and 2 Phillips screwdrivers
❑
Wire insulation strippers
❑
NI-DAQ (current version) for Windows 2000/NT/XP/Me
ni.com
3
SCC-AO10 Isolated Analog Output Module User Guide
ni.com