What You Need To Get Started - National Instruments SCC-SG Series User Manual

bold
italic
monospace
DAQ device
SC-2345
SCC
SCC-SG0X
SCC-SGXX

What You Need to Get Started

© National Instruments Corporation
Bold text denotes items that you must select in software, such as menu
items and dialog box options. Bold text also denotes parameter names.
Italic text denotes variables, emphasis, a cross reference, or an introduction
to a key concept. This font also denotes text that is a placeholder for a word
or value that you must supply.
Text in this font denotes text or characters that you should enter from the
keyboard, sections of code, programming examples, and syntax examples.
This font is also used for the proper names of disk drives, paths, directories,
programs, subprograms, subroutines, device names, functions, operations,
variables, filenames and extensions, and code excerpts.
Data acquisition (DAQ) device refers to all entry-level basic and
full-featured E Series multifunction DAQ devices.
SC-2345 refers to both the SC-2345 connector block and the SC-2345 with
configurable connectors.
SCC refers to any SCC Series signal conditioning module.
SCC-SG0X refers to SCC-SG Series strain-gauge input modules SG01,
SG02, SG03, and SG04.
SCC-SGXX refers to any SCC-SG Series strain-gauge module.
To set up and use the SCC-SGXX, you need the following items:
❑
SC-2345 with one of the following:
– SCC-PWR01
– SCC-PWR02 and the PS01 power supply
– SCC-PWR03 (requires a 7 to 42 VDC power supply, not included)
❑
One or more SCC-SGXX
❑
SCC-SG Series Strain-Gauge Modules User Guide
❑
SC-2345 User Manual
❑
Read Me First: Safety and Radio-Frequency Interference
❑
SC-2345 Quick Reference Label
❑
68-pin Basic or E Series DAQ device, documentation, and 68-pin
cable
5 SCC-SG Series Strain-Gauge Modules User Guide