What You Need to Get Started
Note
Software scaling of measurements is not supported on the Macintosh operating
system. Refer to the
© National Instruments Corporation
To set up and use the SCC-AIXX, you need the following items:
❑
SC-2345/2350 with one of the following:
–
SCC-PWR01
–
SCC-PWR02 and the PS01 power supply
–
SCC-PWR03 (requires a 7 to 42 VDC power supply, not included)
❑
One or more SCC-SGXX
❑
SCC-SG Series Strain-Gauge Modules User Guide
❑
SC-2345/2350 User Manual, available at
❑
SCC Quick Start Guide, available at
❑
Read Me First: Safety and Radio-Frequency Interference
❑
SC-2345 Quick Reference Label
❑
68-pin Basic or E Series DAQ device, documentation,
and 68-pin cable
❑
1/8 in. flathead screwdriver
❑
Numbers 1 and 2 Phillips screwdrivers
❑
Wire insulation strippers
❑
NI-DAQ (current version) for Windows 2000/NT/XP/Me
SCC-AIXX Module Pin Assignments
ni.com
section.
3
SCC-AI Series Isolated Analog Input Modules
ni.com