Care And Maintenance - Champion CHNB500 User Manual

CARE & MAINTENANCE
How to clean
CAUTION: Make sure that the motor base is unplugged from the power source before inserting or
removing any attachment and before cleaning.
NOTICE: Wait until the blender has cooled down suffi ciently before cleaning it.
CAUTION: DO NOT immerse the motor base into water or any liquid, or place into a dishwasher.
1. Separate/remove all parts from each other.
2. Clean the motor base with a slightly damp cloth and wipe dry
3. Place jars in the dishwasher. Place the lids and attachments on the top rack. Take caution
when handling the blade assemblies as the blades are very sharp.
4. Whenever possible, rinse parts immediately after processing to make cleanup easier.
5. Store the product in a cool, dry place.
NOTE:
You may also wash the jars by fi lling the jar to the Max fi ll line with warm water and drop of dish
washing detergent, placing the blade assembly on the jar and pulsing a few times. Do not fi ll the
jar more than Max fi ll line with water because it will overfl ow. Once clean, remove the jar from the
motor base. Rinse the jar, attachment and lid under running water. Allow all the parts to dry before
storing.
Do not use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol, alcohol or
acetone to clean the appliance.
Tips:
• Use a small brush (not included) to remove particles of food lodged underneath the blades.
• If leftover particles dry onto the inside of the jar, fi ll the cup about 2/3 full with warm water
and attach the blade subassembly. Place the jar and blade subassembly onto the motor
base and operate the appliance for about 20-30 seconds to help loosen the stuck
ingredients. Repeat the above step but use clean tap water. Empty blender and dry
thoroughly.
CAUTION:
Do not attempt to remove blades from the Blade subassembly for cleaning.
How to store
1. Store the appliance upright. Do not place anything on top. Store the jars and the rest of the
attachments along the side of the appliance where they will not be damaged and won't cause
a hazard.
2. Remove and empty the jar and ensure that no food is jamming the cutting blades.
3. Allow the appliance to cool for approximately 30 minutes.
4. Re-install the jar onto the base and re-plug the appliance into the electric outlet.
5. Proceed to use the appliance as before while making sure not to exceed the recommended
maximum jar capacities.
EN
6