Using The Blender; Using The Chopper; Cleaning And Maintenance - Champion CHSTM200 User Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

Important information
Check each accessory carefully before using this unit.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use
EN
of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
Before using this unit, check the mains power voltage corresponds to the voltage shown on the marking plate.
Always disconnect the blender from the supply if it is left unattended and before assembling, disassembling or cleaning
Do not allow children to use the blender without supervision
Do not switch the appliance on if it appears to be faulty in any way.
For repairs, accessories or power cord replacement, contact your dealer or an authorized Service Center.
No not immerse the base into water for cleaning and do not start the unit or press the control button with wet hands.
The water temperature should not be over 60℃ when cleaning the unit.
Do not run this unit long-time, otherwise the inner parts will be damaged.
When the motor is running, do not insert your finger or other objects into the machine and container.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in
order to avoid any hazard.
Only use this appliance and the provided accessories.
Use the appliance for its intended purposes only.
Do not use the appliance and the accessories for other purpose than described in this user instruction manual.
Care shall be taken when handling the sharp cutting blades, emptying the container and during cleaning.
Do not try to use the cutting blade or accessory other than the correct purpose to prevent injuries.

Using the blender

Insert the blender bar into motor unit, turn clockwise to lock it into motor unit.
Put ingredients in the beaker to prevent splattering, immerse the blade guard
completely in the ingredients.
Switch the appliance on by pressing the switch Ⅰ or switch Ⅱ.
Blend the ingredients by moving the appliance slowly up, down and in circles.

Using the Chopper

The chopper is perfectly suited for foods such as meat, cheese, onion, herbs, garlic, carrots, walnuts etc. {Cut up cup
maximum capacity 200g)
CAUTION: Don't chop extremely tough food, such as ice cubes, nutmeg, coffee beans and grains. The blades are very
sharp! Be very careful when handing the blade unit.
Put the chopper blade unit in the chopper bowl, press down the blade unit and lock bowl.
Put the ingredients in the chopper bowl, solid ingredients should not be larger than 2 cm pieces.
Put the chopper coupling unit onto the chopper bowl.
Fasten the motor unit onto the chopper bowl.
Switch the appliance on by pressing the switch I or switch II.
Using whisk
The whisk is intended for whipping cream, beating egg whites and mixing sponges and Ready-mix desserts.
lnsert the whisk into the Whisk coupling unit.
Connect the coupling unit to the motor unit.
Press the switch I to activate the hand blender, and press the switch Il after approx. 30 seconds to prevent ingredients
from splashing.

CLEANING AND MAINTENANCE

Before cleaning, unplug the appliance and detach the accessories.
Wipe the motor unit with a moist cloth, do not immerse them in water.
Other accessories can be put in the dishwasher.
If the food is not easily rinsed off the blade, place a drop of dish detergent in
the mixing container with water. Plug cord into outlet. Immerse the blade and
operate the unit for about 10 seconds. Unplug, rinse under running water and then dry.
When storing the unit, keep it in a well ventilated storage area to prevent the motor
being affected with damp.
CAUTION: The cutting edges of the blades are very sharp, clean it carefully.
Champion ®
Makadamgatan 14 I 254 64 Helsingborg I Sweden
info@championnordic.se
Designed in Sweden I Assembled in China

Advertisement

Table of Contents
loading

Table of Contents