Champion CHNB500 User Manual page 5

USE
Assembly
Fig. 1 Fig. 2
IMPORTANT: Place the motor base on a clean, dry, level surface such as a counter or table top.
1. Make sure that the motor base is plugged in for use. No lights will turn on.
2. Add ingredients to the jar.
NOTE: Do not overfi ll! To avoid spilling, do not add ingredients past the "Max" fi ll line.
3. Place the blade onto the jar and twist it on tightly until you have a good seal. (Fig. 1)
4. Turn the jar upside down and place it onto the motor base, aligning the tabs on the jar with
the motor base, aligning the tabs on the jar with the motor base. Turn it clockwise, until you
feel it click into place. The unit is ready for use. (Fig. 2)
5. Press one of the buttons to activate. (Fig.3)
NOTE: When using the Nutri-iQ presets, the unit will operate using pulses, pauses and continuous
runs. The pauses allow the contents of the cup to settle. When the timer reaches "0", it will
stop by itself.
6. To remove the jar, ensure that the motor has stopped running. Then turn the jar counter
clockwise (Fig. 4) and pull straight up to remove. (Fig. 5)
7. Turn the jar upright and remove the blade assembly by twisting the blade assembly counter
clockwise. Be sure to store the Blade Assembly attached to an empty jar when not in use.
8. Twist the Sip & Seal lid onto the jar to enjoy your drink on the go. Press fl ip top cap fi rmly
into the opening to get the best seal. The fl ip top cap locks open when pressed backward.
9. Make sure that the motor base is unplugged when not in use.
10. To remove the motor base unit, tip the unit forward from the rear to easily disengage the
suction cups.
Fig. 3
Removal
Fig. 4 Fig. 5
EN
Fig. 6
4