Care And Maintenance - Champion CHSM115 User Manual

1. Place the motor base on a clean, dry, level surface such as a counter or tabletop.
2. Make sure the unit is unplugged.
3. Add ingredients to the jar.
4. Place the blade onto the jar and twist it on tightly until you have a good seal.(Fig. 1)
5. Turn the jar upside down and place it onto the motor base, aligning the tabs on the jar with the
motor base, aligning the tabs on the jar with the motor base. Turn it clockwise, the unit is ready
for use. (Fig. 3)
6. When you have reached your desired consistency, stop the appliance by turning the jar coun-
terclockwise (Fig. 4) and pull straight up to remove. (Fig. 5)
NOTE: Do not overfill! To avoid spilling, do not add ingredients past the "Max" fill line.
7. Turn the jar upright and remove the Blade Assembly by twisting the blade assembly counter-
clockwise. Be sure to store the Blade Assembly attached to an empty jar when not in use.
8. Place the Sip & Seal lid onto the jar, twist to seal and enjoy!
9. Make sure that the motor base is unplugged when not in use.
Safety features
Built-in safety lock
The blender has a built-in safety lock feature, this ensures that you can only switch on the appli-
ance while the cup and the blade subassembly are assembled on the motor base securely. If the
appliance is correctly assembled, the built-in safety lock will be unlocked.
IMPORTANT:
In the base of each blade's collar, there is a silicone gasket seal that creates
an airtight fit with the jars. After dishwashing and before each use, always
check to make sure the gasket is properly in place, as the heat from some
dishwashers may cause the gasket to become loose.
WARNING: Do not operate the motor continuously for more than 60 seconds at a time.
Allow the motor to rest for 180 seconds before continuing.
NOTICE: If the blade is not running smoothly, stop the product and add some liquid, or
reduce the ingredients in the cup.
NOTE: To prevent product overheating, dry ingredients must not be processed for
more than 30 seconds at a time.
NOTE: To prevent damage to the motor, when the appliance uses 1 speed, first use
pulse mixing and shredding, pulse every 2 to 3 seconds, continuous pulse 3
times.
Care & Maintenance
CAUTION: Make Sure that the motor base is unplugged from the power source before inserting
or removing any attachment and before cleaning.
NOTICE: Wait until the blender has cooled down sufficiently before cleaning it.
CAUTION: DO NOT immerse the motor base into water or any liquid, or place into a dishwasher.
EN
4