Advertisement
1.6.2 Sealing of the device is performed by the producer enterprise.
1.6.3 Removal of seals and repeated sealing is performed by the organization in charge of
repair of the units.
1.6.4 Labeling of the shipping container contains main (consignee and destination),
additional (consigner of goods and origin), and informational (gross and net weight in kg) letterings,
as well as handling marks No.1 "Fragile – Handle with care", No.3 "Protect from humidity",
No.11 "This side up".
The type of the detecting unit (BDBG-09) and the number of the detecting units in packing
box is labeled under the main letterings.
The shipping container with the packed detecting units is sealed by the representative of the
Quality Control Department of the producer enterprise.
1.7 Packing
1.7.1 The detecting unit and the maintenance documentation are packed in a special
cardboard box, which should be placed into a transparent plastic sachet, which is welded after
packing performed.
1.7.2 At shipping, the detecting units are packed into unitized shipping containers (boxes).
Inside surfaces of the walls, bottom and cover of the box should be furnished with corrugated
cradboard.
Note – Other types of unitized containers (containers, cartons) are allowed.
2 PROPER USE
2.1 Operating limitations
2.1.1 The detecting unit is a complex electronic physical device that should be serviced
competently.
2.1.2 Study this document before you start using the detecting unit. All requirements stated in
the technical documents for the detecting unit should be precisely met.
2.1.3 The detecting unit should operate under the conditions that do not fall outside the use
requirements outlined in section 1.2.2.
2.2 Preparation of the detecting unit for operation
2.2.1 Safety measures
2.2.1.1 The detecting unit contains no external parts exposed to voltages hazardous for life.
2.2.1.2 During calibration and testing of the detecting units, if operating with ionizing
radiation sources, the radiation safety requirements stated in valid regulatory documents should be
met - NRBU-97 and DSP 6.177-2005-09 standards.
2.2.2 Volume and order of external examination
2.2.2.1 Before using the detecting unit, unpack it and check if the delivery kit is complete.
Examine for mechanical damage.
Operating manual ВІСТ.418266.006-03 НЕ
10
Advertisement
