Starter Solenoid Replacement - Toro TIMECUTTER 74685 Service Manual

Ignition Switch Testing (continued)
3. START

Starter Solenoid Replacement

Starter Solenoid Removal
TIMECUTTER® Service Manual
3433-938 Rev A
g316681
•
1 — Starting Circuit Terminal
•
2 — (No connection)
•
3 — Battery Terminal
•
4 — Seat Switch and Hour Meter Terminal
•
5 — PTO Switch Terminal
1. Remove the control panel from the right console.
2. Disconnect the harness from the ignition switch. Gently rock the connector
back and forth until unplugged.
3. Using a digital multi-meter set to the OHM or Continuity setting, verify that
continuity exists between the terminals listed for each switch position.
4. Using a digital multi-meter set to the OHM or Continuity setting, verify that
NO continuity exists between the terminals not listed for each switch position.
Position
1. OFF
2. RUN
1. Park the machine on a level surface and set the parking brake. Stop the
engine, wait for all moving parts to stop and remove the key.
2. Flip the operator's seat forward.
3. Disconnect the battery by removing the negative battery cable first, then
the positive cable from the battery.
4. Using a flat head screw driver, pry the solenoid terminal cover off to release
the tabs on the solenoid cover.
Figure 292
Page 8–19
Circuit "Make"
None
2 + 3 + 5 + 4
2 + 3 + 5 + 1
Electrical System: Service and Repairs