Toro TIMECUTTER 74685 Service Manual page 38

Engine Removal (continued)
Engine: Service and Repairs
g300625
16. Remove the hydro belt tensioner spring from the spring anchor point on
the chassis.
g300671
17. Relieve tension from the engine pulley. Slide the hydro belt off the engine
pulley. Remove engine pulley from the crankshaft.
18. Remove the 4 hex bolts (9/16 inch) securing the engine to the chassis.
Note: Three of the bolts will have a flat washer, the 4th bolt going through
the clutch anchor will not have a flat washer.
Figure 17
Figure 18
Page 4–12 TIMECUTTER® Service Manual
3433-938 Rev A