Toro TIMECUTTER 74685 Service Manual page 116

Motion Control Actuator Removal (continued)
Chassis: Service and Repairs
5. Remove the 2 (T-27) screws from the front of the seat pan.
g301717
6. Lift and remove the seat from the seat rod.
g301718
7. Using T–30 torque bit, remove the 3 screws securing the pod to the pod
support brackets. Repeat for opposite side.
8. Remove the fuel cap on the LH side pod.
9. Move the motion control from the neutral lock to the neutral position.
10. Remove the LH pod from the machine.
Note: The LH and RH pod removal are the same except the RH pod has the
control panel and smart speed knob.
11. Reinstall the fuel cap to the LH pod to prevent fuel spill. Fully tighten.
Figure 152
Figure 153
Page 5–66 TIMECUTTER® Service Manual
3433-938 Rev A