Arris SD300 User Manual page 5

FCC Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Note: This equipment has been tested and found to comply with the limits for a Class B
personal computer and peripherals, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy, and,
if not installed and used in accordance with the instructions, might cause harmful
interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this unit does cause harmful interference to
radio or television reception, which can be determined by turning the unit off and on, the
user is encouraged to try to correct the interference by one of more of the following
measures:
•
 R eorient or relocate the receiving antenna.
•
 I ncrease the separation between the equipment and the receiver.  C onnect the
equipment into an outlet on a circuit different from that to which the receiver
is connected.
•
 C onsult the dealer or experienced radio/TV technician for help.
Warning: FCC Regulations state that any unauthorized changes or modifications to this
equipment not expressly approved by the manufacturer could void the user's
authorization to operate this equipment.
Canadian Compliance
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de classe B est conforme à la norme Canadienne NMB
003.
NEC Compliance
The SD300/301 Access Appliance is intended for connection to a cable system, which
has been properly grounded in accordance with the National Electric Code.
UL Compliance
To insure proper operation and UL compliance of the SD300/301 Access Appliance in
the USA, use only an ARRIS-approved power supply.