Connecting The Access Appliance - Arris SD300 User Manual

Chapter 2: Installing the Access Appliance
in mind the consideration noted above and insure the unit is place such that the LEDs and
MAC address label are visible. Also insure that the Access Appliance connections are
accessible.
The figure below demonstrates how to affix the mounting bracket to the Access
Appliance.

Connecting the Access Appliance

The following illustration diagrams the series of steps involved in connecting the parts
together. Many parts have labeled connectors; those labels are in bold type.
Caution: As a precaution , turn off power to the computer and TV (or VCR) before
connecting the cables. ARRIS recommends that you disconnect them from the wall
power outlets.
Note: To ensure proper operation and UL compliance of product in the USA, use only an
ARRIS-approved power supply.
Follow these steps to set up your Access Appliance:
1. Disconnect the TV from the CATV Outlet.
Locate the cable connecting your TV (or VCR) to the wall cable TV/CATV outlet.
Unscrew the end from the wall connector. Leave the other end connected to the
TV/VCR. If you aren't using a TV in the room, skip this step.
Page 12
ARRIS SD300/301 Access Appliance User Guide