Table of Contents
Advertisement
IMPORTANT:
procedures.
1.
Disconnect and remove all cables from the monitor.
2.
Position the monitor facedown on a flat surface covered by protective sheet made of foam or a clean,
dry cloth.
3.
Push up the latch near the bottom center of the stand's mounting plate (1).
4.
Lift the stand up and away from the monitor (2).
Attaching the monitor head to a mounting device
You might need additional tools such as a screwdriver (purchased separately) when you attach a mounting
device. To avoid damage to your monitor, follow these instructions.
1.
Remove the two screws from the stand mount on the back of the monitor head (1).
2.
Lift the stand mount off of the monitor head (2).
3.
Align the VESA mounting plate with the two VESA screw holes (3), and then tighten the screws (4).
8
Chapter 1 Getting started
To position and stabilize the monitor, HP recommends that two people perform these
Advertisement
Table of Contents
