Richell 94951 Instruction Manual page 7

4
Secure the Extension
Adjust Nuts to have space between each Extensions less than
1.8" and tighten them to secure.
Caution
●
If the space between Extensions is 1.8" or more, a cat may pass
through or be caught in the space. If the right and left side of
Extension are not secured with nuts, the similar accident may
occur. Please secure the Extension with the Nuts after adjusting
the space.
5
Install the Door
Insert the Bearing on the Door into the Shaft
on the Frame.
①
6
Install the Plate
Attach the Plate on the Door Frame by the
Screws with the Cushioning Material of the
Plate facing the Outer Frame.
7
Install The Locking Member
Remove one of the Screws from Locking Member, insert
them into the Holes from inside and outside of the Outer
Frame. Secure the Locking Member in a horizontal position
with the Screw.
Shake the upper section and the lower section of
product by holding the Door and Outer Frame to
check if it comes off or wobbles.
Caution
●
Make sure the Gate is secured on daily basis. Please retighten the Adjuster Knobs, Bolts, Screws, Door
Slats and connection area of the Extensions as needed.
②
Shaft
Bearing
Bearing
Shaft
③
Secure with Nuts
Less than 1.8"
Holes for Plate
① Hold the Door with Holes for the Plate
located on the Door Frame up.
② Insert the Bearing on the upper section of
Door into the Shaft on the upper section of
the Frame until it stops.
③ Lower the Door Frame to insert the Bearing
on the lower section of the Door into the
Shaft on the lower section of the Frame.
Plate
Cushioning Material
Outer Frame
Locking Member
Outer Frame
7
Less than 1.8"
Extension
Door Frame Door Frame
Door Frame