Richell Pet Sitter Gate Instruction Manual

TM
Thank you for choosing Richell's Pet Sitter Gate. Please read this instruction manual carefully before
assembling or using this product, and keep for future reference.
Features
Fits openings from 28.3"-41.3" (72-105cm) wide.
Mounts easily with no damage to walls and woodwork.
Designed for small dogs 8.8-17.7 lbs (4-8kg).
Wooden frame coordinates well with home interior.
Adjusters with rubber stopper protect wall and woodwork.
Includes door for ease of confining/removing pet.
Parts / Specifications
Door
Panel with Door Adjuster Panel
Product Name Pet Sitter
Dimension 28.3"-41.3"x2"x20.9" (72-105x5x53cm)
Materials Wooden part of body :
Metal part of body :
Adjuster knob :
Metal part of adjuster bolt :
Rubber part of adjuster bolt :
Cautions
Do not place the product at the top of staircase
or near a glass door.
Place the product against wall with a width of 2.4" or more and
on a flat sturdy surface.
Do not use this product for any other purpose/use other than its
intended purpose.
Keep the product away from fire or extreme high temperatures.
The product is designed for indoor use only. Do not use it outside.
Ensure that the adjuster knobs are tightened securely.
Use mild detergent to clean. Do not always use harsh chemicals
such as benzin or thinner.
This product is designed for use with pets only.
660014
Instruction Manual
Adjuster Bolt(4pcs) Adjuster Knob(4pcs)
Fixing Bolt(4pcs)
Rubber Skid(2pcs)
Spring Washer(4pcs)
Washer(4pcs) Hexagon Wrench(1pce)
TM
Gate
Rubber wood
Steel
Polypropylene
Steel
TPE resin
How to install
Adjust the position of fixing bolts according to the width of installation site.
Note: Tighten the fixing bolts securely with a hexagon wrench.
1. Determine the direction for opening door and set the product against
the wall.
2. Tighten the upper adjuster knob until the rubber of adjuster touches
the wall surface.
3. Tighten the upper adjuster knob until the clearance between the product
and wall is the same on both sides.
4. Tighten the lower adjuster knob to make the product vertical, and stretch
the product fully.
Note: Tighten adjusters equally on both sides to prevent overturning or damage to the product.
Fine-tune the width of installation
Turn adjuster knob clockwise
using adjusters on both sides.
Adjuster Bolt
Attach the rubber skid to the bottom
to prevent scratches to floor surface.
Rubber Skid
Installation Check
If correctly installed, the product should not feel loose or wobbly when tugged. This product should be attached
to wall securely and safely to ensure pet safety and prevent damage to product/wall.
How to open or close the door
Turn the lock up and slide it as shown.
Lock
Designed by :
Richell Corporation, Japan
TM
Pet Sitter Gate
Adjuster Panel
Washer
Spring Washer
Fixing Bolt
Hexagon Wrench
Panel with Door
2.4" or more wide
90-degrees 90-degrees
Note:
Install the product against the wall
vertically.
The bottom of product should
contact the floor.
Note:
Adjust the clearance between the product and wall
on both sides to prevent pet from getting caught
between wall and product
2100 North Highway 360, Suite 1700, Grand Prairie, TX 75050
0704