Richell 94951 Instruction Manual page 6

Set the Gate with the Door opening to the right as seen
from the side where cats are contained.
Place shafts located on the Top and the Bottom of Frame
on the right as seen from the side where cats are contained.
※ If the Gate is installed with the Door opening to the left, a
cat might unlock the door to escape.
1
Stand the Outer Frame
Stand the Outer Frame at
installation location with the
Rubber feet on the bottom.
2
Pull out the Adjuster Knob
Pull the Top Adjuster Knob out from the Outer Frame until the
Rubber on Adjuster reaches the wall.
Rubber on Adjuster
Pull
3
Secure the Outer Frame
① Turn the Adjuster Knob in the direction of
arrow to bring it closer to the Outer Frame.
Adjuster Knob
※ Please tighten the 2 Adjuster Knobs
until no space is between them and
they do not come loose.
Rubber Feet
Caution
Rubber on Adjuster must
be placed in a horizontal
direction.
Side View
② Continue to turn the Adjuster Knob to increase the tension
until the Rubber on Adjuster is securely adhered to the wall.
Follow the same procedure to secure the Bottom Adjuster.
Turn
Outer Frame
6
Top View
Right-Opening
Caution
●
Install this product at right angles
with the wall and floor.
Right Angle
Adjuster Knob
Rubber on Adjuster
Tension Force
Warning
● Make sure the Rubber on Adjusters are adhered to
the wall at 4 locations. If it is not adhered, the Gate
may fall and result in an unexpected accident.
Shaft
Right Angle
3.9" or less
Top View
Right Angle
Side View
Turn