Fp Function; Lock Function; Turbo Function; Set Function - Rotenso CONTROL Series User Manual

Remote contol - DEFO
EN
REMOTE CONTROL SUPPORT

7.7. FP function

To activate the FP function, start the air conditioner in heating mode, set the lowest available temperature
(16°C/60°F), then press the down arrow button 2 times within one second.
If you press any buttons: ON/OFF, Sleep, Mode Fan or up/down button while the FP function is working it will
be canceled.
2

7.8. LOCK function

5s
+
Turbo

7.9 Turbo Function

Press TURBO button
Turbo

7.10. SET function

SET
28
User manual
The unit will operate at high fan speed (while compressor on) with
temperature automatically set to 8°C/46°F.
Note: This function is for heat pump air conditioner only.
5s
Press together Turbo button and Humidity button at the same
time more than 5 seconds to activate Lock function. All buttons
Humidity
will not response except pressing these two buttons for two
seconds again to disable locking.
When you select Turbo feature in COOL mode, the unit will blow cool air
with strongest wind setting to jump-start the cooling process.
When you select Turbo feature in HEAT mode, for units with Electric heat
elements, the Electric HEATER will activate and jump-start the heating
process.
OK