Harmonic ProView 7000 Quick Setup Manual page 9

Configuring the ProView 7000 using EMS
The ProView 7000 has four logical multiplexes. A license is required for using more than one
multiplex.
The basic order of configuring the ProView 7000 is:
1. Configure the DVB-S/S2 input port.
2. Descramble selection – The CAM Slot Properties dialog monitors and manages the
selected CAM slot element. It enables you to map a CAM slot to a multiplex in port and
enable descrambling mode.
3. Descrambling a Program – The ProView 7000 EMS enables you to select individual
programs to descramble.
4. Input Port Mapping – The DVB-S/S2 port in the Physical Input box is mapped by default to
MPEG Multiplex In 1 in the Multiplex Input box. You can map different ports or additional
ports to Multiplex Ins.
5. Stream and Program Routing – The ProView 7000 EMS enables drag-and-drop routing of
an input stream to device outputs.
6. Decoder Set-Up – The ProView 7000 EMS supports drag-and-drop definition of an output
decoding channel and configuration of the decoded program properties.
To configure the ProView 7000 using EMS:
1. If the input stream is received from satellite, perform the following to display and
configure the DVB-S/S2 input port:
i Expand the device tree in the Physical Input box to reveal the DVB in ports.
ii Select the required DVB-S/S2 in port icon in the Physical Input box.
iii Click
© 2010 Harmonic Inc.
How to Configure and Monitor the ProView 7000
on the EMS toolbar.
Properties
9 ProView 7000, v.2.3, Rev. A