Harmonic ProView 7000 Quick Setup Manual page 5

iii Right-click the device icon in the Device box and select
menu.
If the ping fails and the device fails to connect, check your network connections and
settings.
iv Click
How to Configure and Monitor the ProView 7000
You can configure and monitor the ProView 7000 with either the front panel or over an IP
network using the ProView 7000 EMS.
Configuring the ProView 7000 using the Front Panel
■
Monitoring the ProView 7000 using the Front Panel
■
Configuring the ProView 7000 using EMS
■
Monitoring the ProView 7000 using EMS
■
Configuring the ProView 7000 using the Front Panel
The ProView 7000 has four logical multiplexes. A license is required for using more than one
multiplex.
To configure the ProView 7000 via the Front Panel:
1. If the input stream is received from a satellite, navigate
Root > 1 Reception > 1 Configuration
your satellite parameters.
2. If you wish to use GbE output:
i Navigate
ii Configure the IP Address, Subnet Mask and Default Gateway.
iii Select
iv Select
v Navigate
vi Set the Admin Status to Up.
vii Navigate
viii Configure the Destination IP Address and the Destination UDP Port.
ix Set the Socket Status to Up.
3. If you wish to descramble, you must associate the CAM to the multiplex:
i Navigate
ii Select a multiplex, TS1, TS2, TS3 or TS4.
The descrambling mode default is Selective, you can change the mode to Full.
4. To access the CAM MMI menu, select CAM MMI.
5. Select an input port:
i Navigate
ii Select an input port for the received transport stream (Options: SAT 1, ASI 1, ASI 2
and ASI 3).
© 2010 Harmonic Inc.
How to Configure and Monitor the ProView 7000
in the EMS toolbar to display input and output stream trees.
Device Explorer
Root > 4 GbE > 1 GbE Port (1 or 2) > IP Configuration.
.
4 Apply Port Changes
.
1 Apply Changes
Root > 4 GbE > 1 GbE Port (1 or 2) > 3 Admin Status
Root > 4 GbE > 3 Socket Configuration > 1 Socket Out > 1 Socket (1,2,3 or 4)
Root > 6 CAM > CAM (1 or 2) > 1 CAM Association
Root > 3 Routing and Descrambling > 1 TS (1,2,3 or 4) > 2 Input Selection
Connect
and configure the receiver parameters according to
5
in the device context
.
.
.
ProView 7000, v.2.3, Rev. A
.